P90B Ultra Large Rock Splitter for large-tonnage rock and stone mining
Brief introduction to the main view of products:
ultra-large rock splitters with splitting force 1 airborne division force is huge, 3500-5800 tons
2 has the advantages of simple structure, convenient operation, high work efficiency
3 low cost, safety, energy saving, a series of advantages of energy saving management.
To improve the service quality of customer service, enhance customer satisfaction
Product description:
ultra-large rock splitters hydraulic equipment is airborne, need to drill a excavator one. Can drive by pressure. Excavator hydraulic splitter airborne, clean surface and rock between roadbed stonework and rock soil for excavator, make a volley of rock surface increased by drilling equipment, large air compressor selection volley larger the direction or position of the layer rock drilling, drilling in the same section of drill hole porous, distance 1.5-2.5 meters high, the distance between the two holes in 1.5-2.5 meters. ultra large rock splitters toolsCrack width of 4-6 cm.
Two usage:
ultra wedge rock Splitter used in large volume of rock, steep terrain, mountain slope in the upper surface of the dangerous rock, Boulder, and foot from the villagers living area, and high voltage line tower is short, less than the general rock blasting (shallow hole blasting) the minimum distance of 300 meters of the construction project, the construction is very difficult. The lump ore (metals, non-metallic minerals) of the first and two mountain rock disintegration, Ultra Large Rock Splitter collapse, rock quarry mining, large concrete structures and the demolition of all local jobs and other areas.
Three product parameters:
|
Technical parameters of airborne split machine
|
|
model
|
Split block length
mm
|
drilling depth
m
|
nominl workig pressure MPa
|
disruptive forceT
|
crack width
|
Opposite hole form
|
Machine weight
KG
|
|
ZT220-P90
|
800-900
|
1300mm
|
24-25
|
3300-
3600
|
25-
30
|
The chain of manual hole
|
600
|
|
ZT260-P100
|
950-1000
|
1700mm
|
24-25
|
4400-
5200
|
30-25
|
The chain of manual hole
|
650
|
|
ZTN50-P100
|
1000-1200
|
2100mm
|
24-25
|
6000
|
30-25
|
The chain of manual hole
|
730
|
Four airborne splitting machine in use Note:
For your better use of our ultra large rock splitters quarry to avoid undue failure of the hydraulic splitting machine, please be sure to observe the following when using the splitting machine and strictly observe:
1. After the hole depth reaches the standard, the splitter can be inserted into the hole for division.
(Hole depth requirements: splitter front end of the block length + 900mm or more, for example: split block length 600mm, then you must drill more than 1500mm holes can be used before the split machine)
2. Each splitter splits a certain grease after splitting 3-5 holes to reduce the friction between the wedge and the splitter.
3. Do not use the splitter gun as a crowbar to use!
Related Products:
granite rock splitter piston rock splitter Hydraulic DTH Drill
Electric DTH Drill Dual liquid Cement Grouting pump
Automatic feeding shotcreting machine hydraulic electric oil pump
